The exact number can be entered on a spindle. Flutes is the name for that calculates edges. Chip loads are the materials that every cutting edge removes. What number of thousands of an inch will the chip load to be ? this. The standard is that the load on the chip should not be more than 1% of the cutter diameter. It is recommended to cut this amount by half when using smaller mills in order to keep from overloading. If there are a lot of axes of movement, the machine itself is flexible however it could not be able to handle this. To avoid any potential damages to your machine you must research the problem prior to starting. It’s a long and tedious procedure and you should make sure you take your time. For further information, go through this video. 6skylhsgsv.